Vision VISION-64 Uživatelská příručka stáhnout pdf (Strana 13)

Chapter 2 - Installing Vision 13

Chapter 2 - Installing Vision

The Software Protection Key

Upon purchasing VISION you will receive either a unique Software

Protection Key, which plugs into your computers parallel port or a unique

EPROM chip inside the Vision Serial Controller. For VISION to output to

the engraver or perform a graphical print, it is ESSENTIAL

for the key or

EPROM to be in place.

If you have an EPROM chip type Software Protection device, you may skip

over the next set of instructions and proceed to Installing the Vision

Software.

If you have a Software Protection Key, you must follow these instructions:

1) Turn your computer off.

2) Write down the serial number located on the key for future

reference.

3) Plug the male side (the side with the pins) of the key into the

computer printer port.

4) Turn the power on.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 186 187

Žádné komentáře

Vision VISION-64 Uživatelská příručka Strana 13